NJ5-18GM50-E2-V1 Comfort Series Inductive Sensor 50mm

Overview

The Pepperl+Fuchs DC Comfort Series Inductive Sensor 50mm, 1500 Hz, metal conductor, embedded installation, detection distance 5mm, M12 circular 4-pin plug, M18 thread, stainless steel 1.4305 housing, sensing surface PBT engineering plastic, red LED status indicator, IP67 (under the premise of reliable plug locking)

Specification

Item	Specification
Catalog No.	NJ5‑18GM50‑E2‑V1 (76098)
Sensor Type	Inductive proximity sensor
Rated sensing distance	5 mm, flush mount
Output	3‑wire DC PNP Normally‑Open
Operating Voltage	DC 10…60 V
Max load current	200 mA
Switching frequency	1500 Hz
Connection	M12 4‑pin connector
Housing	M18 thread, stainless steel
Dimension	Φ18 mm ×50 mm(body)
Weight	61 g
Protection	IP67
Operating temperature	‑25℃ ~ +70℃
Protection features	Reverse‑polarity, pulse short‑circuit protection

FAQ 

1.What are the rated detection distance and the distance ensuring reliable operation for the NJ5-18GM50-E2-V1 sensor in millimeters?

The

• Rated detection distance Sn: 5 mm
• Ensure reliable working distance Sa: 0 – 4.05 mm

2.Is the NJ5-18GM50-E2-V1 model suitable for flush-mounted installation? And will there be any impact on the detection distance after being buried?

Supported. The

• Allow for flush installation (flush type), which can be fully embedded within the metal base.
• Embedding effect: For standard steel target materials, embedding in the metal base will not reduce the rated detection distance by 5mm.
• If the surrounding material is non-ferrous metals such as aluminum, copper, or brass, even with flush installation, there will still be a significant attenuation in the detection distance.

3.What are the diameter, length of the sensor body and the net weight of the entire machine of the NJ5-18GM50-E2-V1 sensor?

The

• Sensor body diameter: Φ18 mm
• Body length (excluding M12 connector): 50 mm
• Net weight of the entire machine: approximately 61 g

4.For the NJ5-18GM50-E2-V1 model, when multiple sensors are installed side by side at close range, what are the minimum center spacing requirements?

The

• (M18 Parallel Shielded Type), Minimum center-to-center distance of adjacent sensors: ≥ 36 mm (2 times the outer diameter of the housing)
• If the distance cannot be met, a ferromagnetic metal shielding partition can be installed between the two sensors to weaken the mutual magnetic field interference.

Looking for Original  New NJ5-18GM50-E2-V1 Comfort Series Inductive Sensor 50mm