6AG1155-6AA01-7BN0 SIPLUS ET 200SP Interface module

Overview

The SIEMENS SIPLUS ET 200SP PROFINET Interface module, PCB A type triple protection coating, ultra-wide – 40℃ low-temperature startup, mounting: 32 ET200SP IO modules, can be remotely expanded with 16 compact IO modules, supports single-module online hot plugging, can be replaced separately, does not support IRT etc. synchronous mode, DC24V, IP20, 4-channel status LED on the panel

Specification

Item	Specification
Model	6AG1155-6AA01-7BN0
Base Standard Model	6ES7155-6AA01-0BN0
Series	SIPLUS ET200SP IM155-6 PN ST
Max Local IO Modules	32 pieces ET200SP modules
Remote Extension	Up to 16 ET200AL modules
Hot Swap	Single module online hot swap supported
Isochronous Mode	Not supported
PROFINET Port	2-port integrated switch, BA 2×RJ45 default
Transfer Rate	10/100Mbps full-duplex auto-negotiation
Redundancy	MRP supported, MRPD/S2 redundancy not supported
Supply Voltage	DC 24V (19.2~28.8V), reverse & short circuit protection
Typical Power Loss	1.9 W, backplane power feed 4.5 W
Dimension	W50mm × H117mm × D74mm
Weight	147g (with BusAdapter), 120g (bare module)
Conformal Coating	Class A PCB coating (IPC-CC-830A, MIL-I-46058C)
Horizontal Operating Temp	-40℃ ~ +70℃ (condensation/frost allowed)
Vertical Operating Temp	-40℃ ~ +50℃
Max Installation Altitude	5000m (derating above 2000m)
Isolation	PROFINET isolation: 1500V AC type test
LED Indicators	PWR, RUN, ERROR, MAINT; LINK TX/RX
Certification	CE, UL, PROFINET Class1, Non-explosion-proof

FAQ 

1.How many ET200SP IO modules can this 6AG1155-6AA01-7BN0 module locally accommodate at most, and how many ET200AL modules can it externally attach?

The

• Local direct-connection mounting: Up to 32 ET200SP IO modules;
• Remote external expansion: Up to 16 ET200AL modules.

2.What are the maximum input and output process image address spaces in bytes for a single site of the 6AG1155-6AA01-7BN0 module?

Supported. The The input and output process image area of each module’s single site is limited to a maximum of 256 bytes, and the total of input and output is limited to a maximum of 512 bytes.

3.The 4 LED indicators on the 6AG1155-6AA01-7BN0 panel represent what working states respectively?

The

• PWR (green) power indicator light, constantly on indicates normal DC24V power supply;
• RUN (green) operation indicator light, constantly on: the site is operating normally online;
• ERROR (red) fault alarm light, constantly on: severe hardware failure, bus failure;
• MAINT (yellow) maintenance indicator light, constantly on / flashing: firmware upgrade in progress, requires maintenance, I&M maintenance alarm;

4.What is the withstand voltage value for the Profinet network port when it is isolated from the internal circuitry? Is there any isolation for the backplane bus?

The

• PROFINET network interface with internal circuit isolation and withstand voltage
• The network interface is electrically isolated from the internal circuit. The type test withstand voltage is 1500V AC; the DC type test withstand voltage is 707V DC.
• Backplane bus isolation situation
• There is no electrical isolation between the backplane bus and the internal electronic circuit of the module; the power circuit and the internal circuit also have no isolation.

Looking for Original  New 6AG1155-6AA01-7BN0 SIPLUS ET 200SP Interface module