The redundancy mode of 1715-IF16 is realized through duplex hardware matching + software parameter configuration, relying on the overall architecture of the 1715 redundant I/O system to achieve fault tolerance and stable operation:

1. Hardware: 2 1715-IF16 pairs inserted into adjacent slots of the 1715 base, each equipped with a 1715-TADIF16 sensor, and a 1715-AENTR redundant adapter;
2. Software: Studio 5000 selects duplex redundancy mode, configures channel parameters and switching thresholds;
3. Operation: Dual modules collect synchronized data in parallel, automatically switch seamlessly in case of failure, and support hot-swappable replacement.

1715-IF16 can be connected to non-AB brand third-party sensors, but it must meet the conditions of signal type matching and device standard compatibility:

1. Signal type matching: The module supports ±10V, 0 – 10V, 0 – 5V voltage signals and 0 – 20mA current signals. As long as the analog signal output by the third-party sensor falls within the above range, it can be adapted to the 16 independent channels of the module. During adaptation, the signal parameters of the channel must be configured through the Studio 5000 software.
2. Comply with common industrial standards: It is compatible with third-party equipment that supports the ODVA standard, which is a common open standard in the industrial field. Most mainstream brands of industrial sensors will follow this standard design, which provides a basic guarantee for accessing third-party sensors.
3. Adaptation wiring and anti-interference requirements: 22-16 gauge shielded copper wires must be used for access, and the shielding layer should be grounded at one end to reduce signal interference; at the same time, the module channels have 50V continuous isolation capability, which can further adapt to the signal transmission of third-party sensors and ensure the stability of collected data.

Contact US to get a good prices now !