22B-B017N104 selection priority is based on 17.5A as the core matching parameter. The specific brief points are as follows:

1. 5A is the clearly marked rated output current, which better matches the 3.7kW motor power.
2. 17A is most likely due to label simplification or error. Selecting according to this will compress the operating margin and affect the stability when the load fluctuates.
3. Finally, it is necessary to check the official data manual of AB. The rated current of the motor does not exceed 17.5A, and a 10%-20% margin is reserved for scenes with large fluctuations.

The control method needs to be adjusted. It is recommended to switch 22B-B017N104 to V/F control with parabolic characteristics to adapt to the variable torque load characteristics of the HVAC fan and ensure efficient and stable operation of the system.

3.The input voltage range marked on 22B-B017N104 is 200 – 240V AC. If the on-site voltage fluctuates by ±10%, will it affect the normal operation of the equipment?

A short-term ±10% voltage fluctuation will most likely not cause equipment shutdown, but long-term fluctuations will affect operational stability and even damage components. 22B-B017N104 is clearly marked as an inverter with a voltage level of 200 – 240V AC. The input voltage tolerance range is ±10%, which just covers the fluctuation range. However, the impact and response methods of different fluctuation directions are different:

1. Voltage + 10% (about 264V): This voltage does not exceed the withstand voltage protection threshold of the inverter, and the device can operate normally in a short period of time. However, when in this state for a long time, the core magnetic flux inside the inverter will be saturated and the excitation current will increase sharply. This will not only increase the iron loss and heat of key components such as IGBT modules and rectifier bridges, accelerate component aging, but may also trigger the overvoltage protection alarm of the inverter due to overvoltage, and in severe cases, damage the internal capacitors.
2. Voltage – 10% (about 180V): This voltage is lower than the 200V input lower limit of the inverter. Although the inverter has a buffer design with low voltage tolerance and will not shut down immediately, it will cause a series of problems. On the one hand, the motor torque will decrease with the square of the voltage. If it is used for loads such as HVAC fans, the speed may drop and the air volume may be insufficient. On the other hand, the motor will be forced to increase the current in order to maintain the load torque, which will increase the copper loss of the motor and the frequency converter and increase the temperature. In the long term, it is easy to trigger overload protection shutdown and even burn the motor windings.

If the on-site voltage frequently fluctuates by ±10%, it is recommended to install an AC voltage stabilizer to stabilize the input voltage, and to regularly check the operating temperature and current data of the inverter to avoid long-term abnormal conditions that shorten the service life of the equipment.

Contact US to get a good prices now !